Mold Making Supplies and additives
|
|
Amaco Mix-a-Mold
Makes
it easier than ever before to make perfect reproductions of three
dimensional objects. Mix-a-Mold is fast and fun and picks up
every detail. Supplied in powder form, it mixes with water and
the mold is ready in two minutes. Fill the mold with plaster or
any other casting medium.
| 2.5 lbs - List Price $47.95 |
Our price 30% off $33.57
|
|
|
 |
Amaco Rubber Latex
Make castings quickly and accurately with
plaster of paris from molds made with rubber latex. The white,
liquid rubber latex is applied over original models. Completed
molds are tough, flexible and will often withstand 200 to 300
castings. When dry, molds made with Rubber Latex have a weight
loss of 42% Cannot be shipped in freezing
weather.
| 1 pint - List Price $26.95 |
Our Price 30% off $18.99
|
|
|
 |
Water
based Latex, Pint
Water
base latex is one of the more simple materials used to make a flexible
mold. Its ability to reproduce detailed surfaces is very good
and the shrinkage is low. Apply by brushing one coat at a time
over the model, allowing each coat to dry before additional
applications. Mold may be built up with layers of cheesecloth
between coats. |
 |
PureLube plaster
mold release, pint
A
pure liquid (non-detergent) soap separator used as a release when
casting plaster/gypsum into a plaster mold, and to prevent
plaster/gypsum from adhering to most porous surfaces. May be
used full strength or diluted with water. Apply with a clean
sponge until foam appears, dab off excess and repeat the process until
a sheen appears. |
$6
|
|
|
|
Mold Soap, 5 pounds dry
Also known as
Green Soap or Hospital Soap. This concentrated soap has a
consistency similar to Vaseline and must be diluted with warm
water. Application is the same as for Purelube. |
$13
|
|
 |
Sodium
Silicate, pint
Liquid
"N" brand Sodium Silicate is used as a major deflucculant in
preparing slip. It reduces the amount of water needed, therefore
reducing shrinkage. This is a pure sodium silicate and must be
mixed with water to a 50/50 solution for most casting bodies. |
$5.50
|
|
 |
Darvan 7,
pint
A
deflocculant that is user friendly because it has a wide
deflocculation curve. Does not deteriorate molds as actively as
sodium silicate. |
$8
|
|
Mold Straps
Use for slip casting molds. Nylon, 1" wide. Various lengths.
|
 |
3
feet long, yellow |
$3.95
|
|
| 4
feet long, green |
$4.30
|
|
| 5
feet long, blue |
$4.70
|
|
| 6
feet long, orange |
$5.20
|
|
Mold Rubber Bands
Use for slip casting molds.
|
 |
4" x
3/4" inch, 1 pound bag |
$8.15
|
|
| 6" x
3/4" inch, 1 pound bag |
$8.15
|
|
| 7" x
3/4" inch, 1 pound bag |
$8.15
|
|
| 9" x 3/4"
inch, 1 pound bag |
$8.15
|
|
|
